Zapi COMBI AC1 Manual de usuario descargar pdf (Pagina 42)

Page - 42/73 AESZP0BA – AC1 SSL SENSORED - FREE VERSION - User Manual

maximum accelerator position but with two different slope (see also Figure

13–2).

13) THROTTLE Y POINT

These parameter, togheter with the THROTTLE X POINT, changes the

characteristic of the accelerator input curve (see also paragraph 13.5): when

the accelerator is de-pressed to X point per cent, the corresponding truck

speed is Y point per cent of the Maximum truck speed. The relationship

between the accelerator position and the truck speed is linear between the

THROTTLE 0 ZONE and the X point and also between the X point and the

maximum accelerator position but with two different slope (see also Figure

13–2).

14) ADJUSTMENT #01

Adjust the upper level of the battery charge table (Level 0 to 9). See

paragraph 13.6 .

15) ADJUSTMENT #02

Adjust the lower level of the battery charge table (Level 0 to 9). See

paragraph 13.6 .

16) LOAD HM FROM MDI

When set On, the HourMeter of the Controller is transferred and recorded on

the HourMeter of the Standard MDI (connected on the Serial Link).

17) CHECK UP DONE

Turn it On when the asked Maintenance service has been executed to cancel

the CHECK UP NEEDED warning.

18) CHECK UP TYPE

It specifies the handling of the CHECK UP NEEDED warning:

- NONE: No CHECK UP NEENED warning

- OPTION#1: CHECK UP NEENED warning on the hand set and MDI-

PRC after 300 hours

- OPTION#2: Equal to OPTION#1 but Speed reduction after 340 hours

- OPTION#3: Equal to OPTION#2 but the truck definitively stops after

380 hours

19) OPTION 05

(MDI-PRC version only). This setting, togheter with the four settings below,

specifies an offset for the MDI-PRC HourMeter. The MDI-PRC HourMeter will

be the sum of the Controller HourMeter plus this offset. This offset value is 5

Digits with:

- OPTION 05 is the MSDigit

- OPTION 01 is the LSDigit

It is possible to change this offset only when the controller HourMeter is less

than 10 Hours. (It is used when the controller is replaced with a new one to

keep updated the Total Hours measurement of the truck. It is just enough to

set the OPTION 01 to OPTION 05 with the Final HourMeters of the replaced

Controller).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 72 73

Comentarios a estos manuales

Sin comentarios

Zapi COMBI AC1 Manual de usuario Pagina 42

Comentarios a estos manuales

Relacionado con productos y manuales para Adaptadores E Inversores De Energía Zapi COMBI AC1