Zapi AC-2 Manual de usuario descargar pdf (Pagina 34)

Page - 34/83 AF2ZP0CE - ACE2 350/450 - User Manual

7) THROTTLE Y POINT

This parameter changes the characteristic of the accelerator input curve.

VACC MIN and VACC MAX are values programmable by the "Program Vacc"

function.

8) BATT. MIN. ADJ.

It adjusts the lower level of the battery discharge table. It is used to calibrate

the discharge algorithm with the battery of the application. See chapter 9.5

for more information.

9) BATT. MAX. ADJ.

It adjusts the upper level of the battery discharge table. It is used to calibrate

the discharge algorithm with the battery of the application. See chapter 9.5

for more information.

10) ADJUSTMENT #03

This parameter adjusts the updating of battery charge after Key-On.

Decreasing this parameter the difference between the battery voltage

measured after Key-On and the last stored value necessary to update the

charge with the new value measured decrease. It is used to calibrate the

discharge algorithm with the battery of the application. See chapter 9.5 for

more information.

11) LOAD HM FROM MDI

When set On, the HourMeter of the Controller is transferred and recorded on

the HourMeter of the Standard MDI (connected on the Serial Link).

12) CHECK UP DONE

Turn it On when the required Maintenance service has been executed to

cancel the CHECK UP NEEDED warning.

13) CHECK UP TYPE

It specifies the handling of the CHECK UP NEEDED warning:

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 82 83

Sin comentarios

Zapi AC-2 Manual de usuario Pagina 34