Zapi COMBI AC1 Manual de usuario descargar pdf (Pagina 71)

Troubleshooting:

The problem is inside the logic of the inverter, replace the controller.

24) “NO CAN MESSAGE N5”

Cause:

No Can messages from the slave microcontroller.

Troubleshooting:

This alarm could be caused by a canbus malfunctioning, which blinds

master-slave communication. Otherwise it is an internal fault of the controller

which must be replaced.

25) “WRONG SETPOINT”

Cause:

This is a safety related test. The Master µC has detected a Slave µC wrong

hydraulic function setpoint.

Troubleshooting:

This is a internal fault of the controller, it is necessary to replace it.

26) “SAFETY FEEDBACK”

Cause:

This is a safety related test. Master µC has detected a problem on the

feedback of EVP driver.

Troubleshooting:

This is a internal fault of the controller, it is necessary to replace it.

AEQZP0BA – COMBI AC1 - User Manual Page - 71/86

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 85 86

Sin comentarios

Zapi COMBI AC1 Manual de usuario Pagina 71