Zapi COMBI AC1 Manual de usuario descargar pdf (Pagina 69)

AESZP0BA – AC1 SSL SENSORED - FREE VERSION - User Manual Page - 69/73

2) WRONG CONFIG

MDI-PRC Code = 1

- Cause: It occurs the first time a controller is switched on when the non

volatile eeprom memory is not initialized yet. Then it is

necessary to specify if the controller is AC0 or AC1 type (see

AC TYPE 0 in the hidden hardware setting Zapi menu). If the

alarm is present, by switching off the key the AC TYPE 0 setting

will be turned automatically On (and the controller is specified to

be an AC0). The AC TYPE 0 setting can be changed only when

a WRONG CONFIG alarm is present. If it is not present it is

necessary to clear the eeprom memory in order the WRONG

CONFIG alarm occurs.

- Remedy: The AC TYPE 0 setting must be factory adjusted and so this

alarm never should happen when the controller is on the field.

So ask for the assistance of a Zapi technicians when this alarm

occurs.

3) WAITING FOR NODE

MDI-PRC Code = Null

- Cause: The controller expects to receive a messagge from a remote

module via CAN Bus. When this messagge is not received after

a time out this alarm occurs.

- Remedy: Check the communication via CAN between the controller and

the other modules.

4) CURRENT SENS KO

MDI-PRC Code = 94

- Cause: This alarm occurs when the procedure for the maximum current

set-up is in progress.

- Remedy: The maximum current set-up is factory adjusted and so this

alarm never should happen when the controller is on the field.

So ask for the assistance of a Zapi technicians when this alarm

occurs.

14.1.10 Thirty Two Blinks Alarms

1) BATTERY LOW

MDI-PRC Code = Local

- Cause: It occurs when the battery charge is calculated being less than

10% of the full charge and the BATTERY CHECK setting is

other than 0.

- Remedy: Get the battery charged.

1 2 ... 64 65 66 67 68 69 70 71 72 73

Sin comentarios

Zapi COMBI AC1 Manual de usuario Pagina 69